For several years I have been working on prototypes that would mount using the factory receiver bridge scope ring dovetails. (I literally laid awake at night thinking about this. Even dreamed about HOW was I going to mount a SLICK good looking BEAUTIFUL sight on these rifles? Anything with wings, knobs, and clamps looked "CLUNKY" and frankly, life is too short to pack around a "Chunky" "Clunky" sight. Also, anything that would slip on the dovetails and still have windage and elevation adjustment would get too tall and require nose bleed high front sights.

(If a tall front sight was even available. We do not make CZ front sights at this time)

Finally, I decided that anyone who owned a 527 or 550 was most likely discriminating enough to understand that something "SLEEK", "SIMPLE", "ATTRACTIVE", "RUGGED", and "FUNCTIONAL" may require some very simple rudimentary Gunsmithing.

This sight requires two 6-48 holes drilled and tapped in the rear receiver bridge .500" C-C (1/2") apart.

This sight is FULLY WINDAGE AND ELEVATION ADJUSTABLE COMES WITH INSTRUCTIONS, MOUNTING SCREWS, and WRENCHES and our .096" APERTURE INSTALLED.

This sight also works on the RUGER 77, Mark II 77, and Hawkeye rifles. Same drill and tap application as above.

CZ

CZ 527/550 Sight